| 1, Impact Crusher can effectively handle the large | | | | achieved by replacing the bottom of the sieve plate. |
| amount of moisture content of materials, to prevent | | | | 4, Impact Crusher wear wearing parts than the |
| the blockage of the phenomenon of Crusher | | | | hammer crusher is small, high utilization rate of metal |
| In dealing with excessive moisture content of materials, | | | | Hammer Mill wear plate only appears in the Looking |
| the counter-attack crusher feed chute and the back | | | | material side. When the rotor speed is normal, the feed |
| plate can be equipped with heating devices to prevent | | | | will drop to the board hammer surface (of attack), |
| the bonding material. Impact Crusher is equipped with | | | | hammer on the back and side panels are not being |
| the bottom of the sieve plate do not need to be | | | | worn. Even Looking material this side of the wear and |
| effective in preventing clogging phenomenon. The | | | | tear would be minimal. And the bottom of the grinding |
| hammer crusher can not be used to prevent heating | | | | rod is also very easy to replace. Back-breaking |
| of the bonding material, and shall be equipped with the | | | | hammer the metal plate up to 45% utilization rate of |
| bottom of the sieve plate, increasing the possibility of | | | | -48%. The hammer crusher hammer was hanging |
| clogging. | | | | condition, wear and tear occurred, the front and rear |
| 2, back-breaking not only for soft materials also applies | | | | and side, relative to the plate hammer, hammer wear |
| to very large hardness of materials | | | | and tear is more serious, hammer metal utilization ratio |
| Hammer Crusher board mechanical clamping structure | | | | is only about 25%. And the rotor body itself may be |
| firmly set at the rotor, when the rotor rotates, with the | | | | subject to wear and tear. Hammer Mill wear seriously |
| great moment of inertia. Relative to the hammer | | | | affected by the bottom of the sieve-plate, grille should |
| crusher (hammer was hanging state), back-breaking of | | | | all replace, and replace the sieve of the work more |
| the rotor has a greater momentum, crushing harder to | | | | complicated. |
| adapt to the material, were also lower power | | | | 5, Impact Crusher spare parts replacement is simple, a |
| consumption. | | | | corresponding reduction in maintenance costs |
| 3, Impact Crusher can be easily adjustable and flexible | | | | Broken rotor only counter to install six panel hammer, |
| discharge particle size, a wide range of adjustment | | | | special tools can be easily board hammer replacement, |
| Impact Crusher can be adjusted through a variety of | | | | the replacement of a board of only one frequency |
| ways out of material particle size, such as the | | | | hammer time. The bottom of the grinding chamber |
| regulation of rotor speed, adjustable back plate and | | | | grinding rod replacement also requires only several |
| grinding chamber gap and so on. Gap adjustment can | | | | minutes, greatly reducing the repair and maintenance |
| be mechanical or hydraulic adjustable, | | | | time and costs. The hammer crusher hammer up to |
| hydraulic-conditioning systems can be easily adopted | | | | more than 100, with the replacement of a hammer to |
| by local operating buttons or remote controls system | | | | spend a lot of time and manpower, repair and |
| to complete the space adjustments. The hammer | | | | maintenance costs higher. The bottom of the screen |
| crusher discharge size adjustment can only be | | | | plate and its replacement is also troublesome. |